|
Pricing Guide to estimate the approximate cost of HVAC work for property improvements.
Basic materials are included in these costs but special purchases are not.
The prices listed below are "industry averaged" and do not represent the prices or costs of any
particular company affiliated with Contractors Solutions Inc.
HVAC Mechanic Service Call
- Urgent trouble call service, travel, diagnostics service - $125.00.
HVAC Mechanic Service Call
- Scheduled diagnostics service - $90.00.
A/C Thru-Wall - Remove and replace an existing thru-wall A/C unit - $175.00
A/C Thru-Wall - Cut wall and installation for a new thru-wall A/C unit - $320.00
New Installations - Replace / install / connect a residential furnace - $525.00
New Installations - Replace / install / connect a residential central A/C condensing unit - $650.00
New Installations - Set up / install / connect a residential A/C air-handler unit - $400.00
New Installations - Set up / install / connect a residential oil tank - $380.00
New Installations - Roof Curb frame work, or pre-constructed (includes roof cut) - $650.00
New Installations - Roof Pitch-Pocket (includes roof cut) - $325.00
Heat-Pump, Electrical tune-up single phase heat pump or air conditioner;
Replace contactor, add hard start kit, replace damaged wiring and terminals - $150.00
Heat-Pump, Replace condenser fan motor on 1.5 to 5 ton (double shaft motors add $150.) $300.00
Heat-Pump, Replace compressor 1.5 to 5 tons. Includes re- piping, additional refrigerant, replace wires and terminals - $1,500.
Heat-Pump, Replace contactor single phase unit - $55.00
Heat-Pump, Replace contactor three phase unit - $85.00
Heat-Pump, Install liquid line sight glass and dryer - $250.00
A/C - Heat-Pump, Mechanical tune-up with liquid line sight glass, dryer, high and low pressure controls,
anti-restart timer (also known as the "rental property package") - $500.00
A/C - Heat-Pump, Mechanical tune-up replace indoor coil includes with thermostatic expansion
valve, hard start kit and sheet metal modifications - $1,000.
A/C - Heat-Pump, Mechanical tune-up to add thermostatic expansion valves inside and out to a
heat pump, includes hard start kit, re-wiring and piping modifications - $700.00
A/C - Heat-Pump, Repair leaks on indoor coil "spider tubes", add expansion valve, high and low pressure controls,
anti-restart timer, start kit (2 expansion valves for heat pump add $200.) - $500.00
A/C - Heat-Pump, Install / Modify system to a heat pump (no change to existing fuel) - approx. 2,500.
A/C - Heat-Pump, Install / Modify system to a heat pump (change made to 100% electric) - $3,700.
Maintenance Repair, Replace duct filter - $ 40.00
Maintenance Repair, Check for gas leaks - $ 70.00
Maintenance Repair, Carbon Monoxide test - $175.00
Maintenance Repair, Check and clean standard gas furnace (oil furnace add $68.00 for filter and nozzle) - $140.00
Maintenance Repair, Check and clean standard central A/C system (rooftop units add $50.00) - $100.00
Heating, Replace gas valve on furnace or boiler (standing pilot) and a new thermocouple - $400.00
Heating, Replace gas valve on furnace or boiler (intermittent pilot or proven pilot) - $450.00
Heating, Replace gas valve on furnace or boiler (Milli-volt to standard standing pilot) - $350.00
Heating, Replace gas valve on furnace or boiler to intermittent pilot or direct spark
including ignition module wiring, pipe fittings and new pilot tubing - $650.00
Heating, Replace gas valve on furnace or boiler to hot surface igniter (HSI), direct spark - $350.00
Heating, Replace induced draft fan motor on furnaces or boilers, includes replacement motor - $400.00
Heating, Repair defective or broken HIS system with spark module - $180.00
New Installations, Set up / install / connect a new 1.5 to 5 ton central A/C system - $1,300.00
New Installations, Set up / install / connect a residential central A/C flex-duct system - $1,300.00
New Installations, Set up / install / connect a residential boiler - $1,400.00
Open to all Contractor Trades in the Delaware Valley. |
Cooling
